Water Heater Repair – Easy Tips to Save Money

Water Heater Repair is not that difficult to get over if you take the right approach. The average lifespan of a residential water heater is ten to twelve years, and the way that the water heater is being kept maintained will play a huge role in its longevity. Some easy routine maintenance such as flushing the burner monthly and yearly replacing of the anode can prolong its lifespan quite a bit. If you are really looking into extending your heater’s life, you will want to pay attention to the following tips.

The first thing you want to look at is your water heater’s thermostat. This is the device that controls the flow of the water through the system, and once the flow rate gets out of control, it can cause your water heater to work hard to keep up. So with this in mind, make sure you check and change the value inside of the thermostat on a regular basis. Also, make sure that there are no cracks in the cover or insulation. If any of these things are found, you will want to replace them as soon as possible. Also, you should look at the motor housing, as often times it can break down and the wires inside can become frayed, which will also cause the motor to work overtime and to burn out.

Another of the common water heater repair tips is checking the heating element. In this case, you will need to unplug the system before you can access the element. Usually the element will glow green when you first access it, but overtime it may start to turn red. Make sure to check the power cord, as sometimes this is the source of the problem. If you do not know how to do this, contact a heating and water service provider for assistance. Again, most times these problems can be easily fixed by replacing the element.

One of the more common repairs that need to be done is the thermostat motor. This is the part that controls the flow of the heating element and if it becomes damaged, it can actually prevent the heater from working. To perform this heater repair, you will first need to remove the two screws that hold the thermostat in place. Once this is done, you can replace the motor with a new one and put everything back together.

The final step in a water heater repair is to check the pilot light to ensure that it is functioning properly. If the pilot light is smoking or if it is not working, you will need to replace it. It is important to note that you should only replace the light if it is smoking because if it is not smoking then the problem may not be with the pilot light, but with the heating element itself. Typically, all three parts are replaced if the plumber thinks the problem is serious enough to warrant going to a professional.

A great thing about doing water heater repairs yourself is the fact that you can save money. If you were to hire a professional to fix the issue, chances are you would have to pay at least several hundred dollars. While some plumbers charge more than others, there are plenty of good plumbers out there that are reasonably priced. This is better than having to repair the problem on your own and at least have the option of a cheaper professional to come out and fix the issue for you. Check online to find a great local plumber that can perform any of these three repairs, and you should be able to get your water heater repaired easily and fairly inexpensively.

Leave a Comment